Speed Queen Coin Slot Stuck
Speed Queen Washer Not Rinsing And / Or Stuck at __ minutes.
I was recently out of town and got a call that one of my Speed Queen washers was having problems.
Put another coin into the slot and attempt to use this action to dislodge the stuck coin. Slap the side of the machine where the coin slot is located to get the coin to move. Place a piece of wood or something to protect the finish of the machine and tap on the wood with a hammer to unjam the coin. If you live in an apartment and it has coin operated laundry I got you fam. The most popular brand of washing machine is a 'Speed Queen' if your apartment complex uses Speed Queen you are in luck. Go on eBay and buy a Speed Queen 800 key. Its a hex key, looks like a circle with a little knob on one part. Some Older Huebsch and Speed Queen Stack units may use only the 6″ tray, while newer machines accept the higher capacity 8″ tray. Wascomat prior to 2000 machines use the 6″ trays (JBL), Wascomat after 2000 use 8″ trays (JBX). Also note that some new models of Speed Queen / Huebsch and Dexter may take a GBE 8″ box. New machines you can't do that, older ones work. But without any tools on that machine I could get it free faster then that. The machine has that thing you put the coins I then push it in, well get some plastic coffee stir sticks there free at restarants grab a bunch put into the coin slotsat about a 45 degree angle and push it I the coin thing will push in then pull it back and remove your.
I’m continually working with my attendants to provide as many details as they can about any problems as it is all used to determine the root cause of the issue. Many times it is difficult for them if the store is busy so sometimes you have to piece together a couple of comments.
In this case, one of my attendants had a problem and put some Caution Tape on the washer. Unfortunately, the details were not written in the log book. The next attendant came in the following day, saw the tape and tried a cycle.
Another cycle was tried later in the day after they had cycled the power.
Through the course of a couple of phone calls and some discussion when I got back I got a better picture of the problem.
Comments: “It stopped at 12 minutes and stayed there”, It stopped at 19 minutes and stayed there”, “The clothes were soaked when we pulled them out”.
Once I was able to look at it I found that the washer filled the wash cycle fine on a Hot cycle but not on a cold cycle. The next item I found was that the detergent flush was working OK but the rinse cycle was not filling up.
Listening to the water line I could tell there was some cold water flow through the fill valve but not much.
I switched the wires between the flush and fill valve to determine if it was a wire or connector problem but nothing changed.
Speed Queen Coin Slot Stuck Behind
Once the cold water valve was changed everything worked fine.
The repair is not that difficult.
Power off the machine, Take a picture of the wire connections, unbolt the valve, switch the wires one at a time to the new valve, switch the hoses one at a time to the new valve and bolt it back in.
Total time is about 30 minutes to change the valve.
If you have any comments please post them below.
Speed Queen Coin Slot Stuck Inside
Ken